How to use a dry bulk tanker trailer?

Dry bulk tanker trailer is also called cement bulker, silobas or silo trailer. It is mainly used for the bulk packing of powder dry materials such as fly ash, cement, lime powder, ore powder, granular alkali, aluminum powder, etc. transport. How to use the powder tank truck? Below we will share with you.

Instructions for powder tanker operation

Dry bulk tanker safety inspection before operation

1. Perform routine inspection according to the axle axle manual of the dry bulk tanker trailer;

2. Check the tank, frame, suspension and key components for cracks or loose bolts;

3. Check whether the lighting and braking system are normal;

4. Check whether the manhole, intake valve and discharge valve can be opened and closed normally;

Unloading steps of powder tank truck

1. Before unloading, check whether the unloading disc valve, external air source interface, exhaust valve and two feed ports are closed and tightened. If not, tighten it first to prevent air leakage;

2. Start the engine and shift the transmission to neutral, and step on the clutch pedal at the same time to completely separate the transmission from the engine;

3. Turn on the power switch solenoid valve switch, and at the same time slowly release the clutch pedal to make the air compressor rotate;

4. Adjust the control handle of the control mechanism, adjust the speed of the pneumatic sand trailer air compressor to about 900r / min, and stabilize it;

5. When the pressure reaches 0.18MPa, first open the auxiliary blowing pipe, then open the front and rear warehouse unloading disc valve to start unloading, after which the pointer of the air compressor will stabilize a certain value;

6. When the air pressure drops to 0.04Mpa, the rear bin has been unloaded, close the auxiliary blower, open and close the disc valve a few times, and then close the rear bin disc valve and the rear bin inlet valve, that is, only the front bin is discharged , After which the pressure will rise and stabilize to a certain value;

7. When the pressure of the air pressure gauge reaches 0MPa, the discharge is completed, turn off the air compressor (close the power take-off switch), and close the discharge disc valve.

Welcome to click “Resource“, you can get more article about our trailers.

Click “Product“, you can find your favorite semi trailer.