Red Mud Settling Flocculants

SINOFLOC red mud setting flocculants is used for settling aluminum red mud slurries in alumina plants, which provide high settling rates, better separation performance and reducing suspended solids significantly. SINOFLOC products could improve the liquor filtration operations and make the processing more economical.

Red Mud Settling Flocculants Specifications

SINOFLOC DT 9619 is with very high molecular weight, powder based, to be used in alumina plants to settle red mud slurries of extraction of aluminium or alumina refinery . It contains anionic polyacrylamide functional groups with high anionic charge.

SINOFLOC DT 991 is with high molecular weight, emulsion based, to be used in used to settle mud in the red mud washing circuit of refining aluminium. These products are a combination of acrylamide and acrylate with very high anionic charge.

Application Area:

SINOFLOC products could be used in alumina bayer process. Red mud settling requires using the efficient flocculants to bridge and entrap the find red mud solids to separate the solids from liquor rapidly. The more efficient of our flocculants in this process, the lower the cost of red mud separation. SINOFLOC red mud flocculants provides a unique advantage for alumina refinery industry refiners to address productivity improvement and total cost of operation of extraction of aluminium oxide.

FAQ

What Kinds of Polyacrylamide are Available in Sinofloc for Red Mud Settling?

Sionfloc polyacrylamide for refining aluminium is available in powder and emulsion and status.

What the Mechanism of Function of Red Mud Settling Flocculants?

What Factor Will Influence the Consumption of Flocculants?

Instructions

The Selection of Polyacrylamide in Mining

There are four kinds of ionic types of polyacrylamide, and there are different levels of species under each ionic type. What type of polyacrylamide can be applied to mineral processing industry? Polyacrylamide can be widely used in mining process, such as copper ore, iron ore, gold flotation and tailings water treatment, coal washing, flocculation and water treatment, starch and distiller's grains recovery in starch factories and factories. The experiment was carried out on the selection of anionic polyacrylamide wastewater. It was found that the experimental results were obvious. High grade iron ore is obtained by selection of low grade iron ore (wet screening, gravity dressing, magnetic separation and flotation). The ore dressing is mainly polluted by waste water and waste residue. In the lead and zinc filtration process, anionic polyacrylamide is used to accelerate the settling of minerals and clarify the filtrate, improve the efficiency of production and reduce the loss of minerals. In the process of aluminum ore processing, the mineral is broken and crushed to less than 1mm grade. The concentration of sodium hydroxide and high temperature and high pressure are added. After the above process, the gravel is removed together with the slurry that has been precipitated by the primary concentration. Anionic polyacrylamide flocculants was added to the primary concentration pool. The red mud thickener will processed by underflow through an inverse return process of settlement. At this time, the anionic polyacrylamide flocculants is used again to promote rapid settlement and to get the required clarification overflow. The primary concentrating pool rich in aluminum is filtered, and after cooling (48 hours), the hydrates are filled with aluminum to promote the precipitation of three hydrates of the aluminum.

SINOFLOC has become a leading manufacturer and supplier of water-soluble polymers in China. We offer flocculant for alumina processing, cationic polymer polydadmac, oilfield chemicals, etc. Contact us to know more.