INVENTIONS - 325 Annonces

Wednesday 11 June 2014

Application: XB-ZSG1L is a white flashing light fixture and can be set in the approaching-direction area of the heliports. The product can send out white omnidirectional flashing light signal at night or during low visibility weather, which clearly marks out the main approaching...

Wednesday 11 June 2014

Application: XB-ZMZ1L is a inset light fixture and installed along the aiming signs evenly. The product can send out white omnidirectional steady burning light signal at night or during low visibility weather. Usually, at least six lights can provide an accurate landing position...

Wednesday 11 June 2014

Application: XB-ZFG1L is vertically installed light and can be boundary marking of touchdown and lift-off (TLOF) area. The product provides unidirectional steady-burning white light, which supplies floodlighting for helipad surfaces. As using the product, the average surface illuminance...

Wednesday 11 June 2014

Application: XB-ZHG1L is a white steady burning light fixture and can be set in the approaching-direction area of the heliports. The product can send out white omnidirectional steady burning light signal at night or during low visibility weather, which clearly marks out the main...

Wednesday 11 June 2014

Application: Meteorological target lamps can provide more accurate information and representative reference for the visually dominant visibility. Patents: - Developed product and owns independent intellectual property rights for product - Optical lens which is solely developed...

Wednesday 11 June 2014

Application: XB-FXB1L is used to provide visual surface wind direction and velocity information to pilots in helicopters over the final approach and takeoff areas. Each airport must be set at least one wind cone, and its installation location should be chosen not to be disturbed...

Wednesday 11 June 2014

Application: LED-series taxiway signs (hereinafter referred to as signs), are essential products for airfield lighting systems. The signs provide direction and information to taxiing aircraft and airport vehicles, including indicating the direction to turn with an arrow,identifying...

Wednesday 11 June 2014

Application: - The low-intensity LED aviation obstruction light is used as a steady-burning red light that marks all fixed obstructions to prevent air navigational hazards. - When fixed obstructions are less than 45m, a single light can be used. - When fixed obstructions are more than 45m...

Wednesday 11 June 2014

Application: - Medium intensity LED aviation obstruction light is used as flashing-burning white light that marks all fixed obstructions to prevent air navigational hazards. - When fixed obstructions are more than 45m, two or more lower intensity lights should be installed in...

Wednesday 11 June 2014

Application: - The low-intensity LED aviation obstruction light is used as a steady-burning red light that marks all fixed obstructions to prevent air navigational hazards. - When fixed obstructions are less than 45m, a single light can be used. - When fixed obstructions are more than 45m...

Wednesday 11 June 2014

Application: - The low-intensity LED aviation obstruction light is used as a steady-burning red light that marks all fixed obstructions to prevent air navigational hazards. - When fixed obstructions are less than 45m, a single light can be used. - When fixed obstructions are more than 45m...

Wednesday 11 June 2014

Application: - The low-intensity LED aviation obstruction light is used as a steady-burning red light that marks all fixed obstructions to prevent air navigational hazards. - When fixed obstructions are less than 45m, a single light can be used. - When fixed obstructions are more than 45m...

Wednesday 11 June 2014

Application: - The low-intensity LED aviation obstruction light is used as a steady-burning red light that marks all fixed obstructions to prevent air navigational hazards. - When fixed obstructions are less than 45m, a single light can be used. - When fixed obstructions are more than 45m...

Wednesday 11 June 2014

Application: - Medium intensity LED aviation obstruction light is used as flashing-burning white light that marks all fixed obstructions to prevent air navigational hazards. - When fixed obstructions are more than 45m, two or more lower intensity lights should be installed in...

Wednesday 11 June 2014

Application: - Medium intensity LED aviation obstruction light is used as flashing-burning white light that marks all fixed obstructions to prevent air navigational hazards. - When fixed obstructions are more than 45m, two or more lower intensity lights should be installed in...

Wednesday 11 June 2014

Application: - The low-intensity LED aviation obstruction light is used as a steady-burning red light that marks all fixed obstructions to prevent air navigational hazards. - When fixed obstructions are less than 45m, a single light can be used. - When fixed obstructions are more than 45m...

Wednesday 11 June 2014

Application: - The low-intensity LED aviation obstruction light is used as a steady-burning red light that marks all fixed obstructions to prevent air navigational hazards. - When fixed obstructions are less than 45m, a single light can be used. - When fixed obstructions are...

Friday 22 November 2013

Quantité : *** - Prix : ***

Cement Introduction Cement in powder form can be changed from plasticity paste to hard stone-like body and can become a total cemented granular materials through physical and chemical processes after being mixed with water. So cement is a good mineral binder. Cement can be not only...

Tuesday 20 August 2013

Quantité : 1 ton - Prix : 5-17 USD

Specifications: cores Material: Plastic Width: Film Slit Width + or - 0.2mm Inner Diameter: 75mm +1.0mm or -0.5mm Roll Outer Diamter For slit widths 25.0mm up: 240+10 or -20mm For slit widths 37.5mm up: 320+10 or -40mm For slit widths 10.0mm up: 180+8 or -18mm For slit widths 4...

Tuesday 20 August 2013

Quantité : 1 piece - Prix : 0.3-1.5 USD

Specification CBB60 copacitor takes heavy-edge metalized Al/Zn PP film as electrodes and dielectric. It's components are sealed with flame redardant epoxy resin. It has cylindricaloutline with high moisture resistance and stability. Features Model CBB65 CBB60 CBB61 Material...

Tuesday 20 August 2013

Quantité : 1 piece - Prix : 0.3-1.5 USD

Specification CBB60 copacitor takes heavy-edge metalized Al/Zn PP film as electrodes and dielectric. It's components are sealed with flame redardant epoxy resin. It has cylindricaloutline with high moisture resistance and stability. Features Model CBB65 CBB60 CBB61 Material...

Tuesday 20 August 2013

Quantité : 1 piece - Prix : 0.3-1.5 USD

Specification CBB60 copacitor takes heavy-edge metalized Al/Zn PP film as electrodes and dielectric. It's components are sealed with flame redardant epoxy resin. It has cylindricaloutline with high moisture resistance and stability. Features Model CBB65 CBB60 CBB61 Material...

Tuesday 20 August 2013

Quantité : 1 piece - Prix : 0.3-1.5 USD

Specification CBB60 copacitor takes heavy-edge metalized Al/Zn PP film as electrodes and dielectric. It's components are sealed with flame redardant epoxy resin. It has cylindricaloutline with high moisture resistance and stability. Features Model CBB65 CBB60 CBB61 Material...

Tuesday 20 August 2013

Quantité : 1 piece - Prix : 0.3-1.5 USD

Specification CBB60 copacitor takes heavy-edge metalized Al/Zn PP film as electrodes and dielectric. It's components are sealed with flame redardant epoxy resin. It has cylindricaloutline with high moisture resistance and stability. Features Model CBB65 CBB60 CBB61 Material...

Tuesday 20 August 2013

Quantité : 1 piece - Prix : 0.3-1.5 USD

Specification CBB60 copacitor takes heavy-edge metalized Al/Zn PP film as electrodes and dielectric. It's components are sealed with flame redardant epoxy resin. It has cylindricaloutline with high moisture resistance and stability. Features Model CBB65 CBB60 CBB61 Material...

Tuesday 20 August 2013

Quantité : 1 piece - Prix : 0.3-1.5 USD

Specification CBB60 copacitor takes heavy-edge metalized Al/Zn PP film as electrodes and dielectric. It's components are sealed with flame redardant epoxy resin. It has cylindricaloutline with high moisture resistance and stability. Features Model CBB65 CBB60 CBB61 Material...

Tuesday 20 August 2013

Quantité : 1 piece - Prix : 0.1-1 USD

Specification CBB61 capasitor takes heavy edge metalied Al/Zn film as electrodes and dialectric. It is imprenated with flame-redardant epoxy resin and canned cubic ABS or PBT plastic case with chracteristiccs of small size, reliable performance and long endurance. Features Model...

Tuesday 20 August 2013

Quantité : 1 piece - Prix : 0.1-1 USD

Specification CBB61 capasitor takes heavy edge metalied Al/Zn film as electrodes and dialectric. It is imprenated with flame-redardant epoxy resin and canned cubic ABS or PBT plastic case with chracteristiccs of small size, reliable performance and long endurance. Features Model...

Tuesday 20 August 2013

Quantité : 1 piece - Prix : 0.1-1 USD

Specification CBB61 capasitor takes heavy edge metalied Al/Zn film as electrodes and dialectric. It is imprenated with flame-redardant epoxy resin and canned cubic ABS or PBT plastic case with chracteristiccs of small size, reliable performance and long endurance. Features Model...

Tuesday 20 August 2013

Quantité : 1 piece - Prix : 0.1-1 USD

Specification CBB61 capasitor takes heavy edge metalied Al/Zn film as electrodes and dialectric. It is imprenated with flame-redardant epoxy resin and canned cubic ABS or PBT plastic case with chracteristiccs of small size, reliable performance and long endurance. Features Model...